IF5253 (Discontinued) 1700C Bench-Top Muffle Furnace KSL-1700X-A1

Furnace Structure

• Double-layer steel structure with air cooling fan to keep the surface temperature of the case below 60℃
• High-purity alumina fiber insulation for max. energy saving
• Overheating and burnout protection, power-off when opening the door
• 1760 ℃ (3200 ℉) Hi-Purity Alumina Coating inside the chamber for longer service life

Temperature Controller

• Double-layer steel structure with air cooling fan to keep the case's temperature below 60℃
• High purity alumina fiber insulation for max. energy saving
• 1760 ℃ (3200 ℉) Hi-Purity Alumina Coating inside the chamber for longer service life

Inside Chamber Size

• 160mm x 150mm x 150mm (6.3" x 5.9" x 5.9"), 3.6L

France Door Block Dimension

• 138mm x 138mm (5.4" x 5.4"). Thickness: 60mm

Standard Working Temperature

• 1600℃or 2912℉ (continuous)

Maximum Working Temperature

• 1700℃or 3092℉ (< 3 hours)

Heating Rate

• 0 ~20 ℃/min (≤10℃/min recommended)

Temperature Accuracy

• +/- 1℃

Temperature Uniformity

• +/- 5℃ over 120 mm (5") @ 1700℃ 
• +/- 2℃ over 80 mm (3") @ 1700℃

Thermocouple

• B-Type (Pt-Rh to Pt-Rh) with Alumina tube 

Working Voltage

• AC 208V-240V single phase, 50/60 Hz (35A air breaker required)
• Note: Plug is not included, and it is suggested you use NEMA L6-30P plug for AC 208~240V)

Max. Power

• 4 KW

Outside Size

• 515 x 500 x 730 mm (20.28" x 20" x 28.75")

Net Weight

• 100 Kg (230 lbs.)

Warranty

• One-year limited warranty with lifetime support.  
• ATTENTION: Any damages caused by the use of corrosive and acidic gasses are not under the coverage of SAM One Year Limited Warranty.

Compliance

• CE Certified
• NRTL or CSA certification is available upon request at an extra cost

Shipping Dimensions

• 48" x 40"x 45"

Shipping Weight  

• 350 lbs.

Application Notes

• Warning: MoSi2 heating element is used in the high temperature under the oxidizing atmosphere. It will form the SiO2 film which can keep the element from being melted. During the oxidizing process, the SiO2-protecting film is formed again when the element continues to be used. The MoSi2 heating element must not be used at a temperature between 400 ℃ and 700 ℃ for a long time, otherwise, the element will be cremated under the strong oxidizing function at the low temperature.