NB1708 Niobium Aluminide (NbAl3) Powder (CAS No. 12004-70-5)

SECTION 1. IDENTIFICATION

Product Name: Niobium Aluminide NbAl3

CAS #: 12004-70-5

Relevant identified uses of the substance: Scientific research and development

Supplier details:

Stanford Advanced Materials

E-mail: sales@samaterials.com

Tel: (949) 407-8904

Address: 23661 Birtcher Dr., Lake Forest, CA 92630 U.S.A.

---

SECTION 2. HAZARDS IDENTIFICATION

Classification of the substance or mixture

Classification according to Regulation (EC) No 1272/2008

The substance is not classified as hazardous to health or the environment according to the CLP

regulation.

Classification according to Directive 67/548/EEC or Directive 1999/45/EC

N/A

Information concerning particular hazards for human and environment:

No data available

Other hazards that do not result in classification

No data available

Label elements

Labelling according to Regulation (EC) No 1272/2008

N/A

Hazard pictograms

N/A

Signal word

N/A

Hazard statements

N/A

Other hazardsResults of PBT and vPvB assessment

PBT:

N/A

vPvB:

N/A

---

SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS

Substances

CAS# Designation:

12004-70-5 Niobium aluminide

---

SECTION 4. FIRST AID MEASURES

Description of first aid measures

If inhaled:

Supply patient with fresh air. If not breathing, provide artificial respiration. Keep patient warm. Consult

doctor if symptoms persist.

Seek immediate medical advice.

In case of skin contact:

Instantly wash with water and soap and rinse thoroughly.

Seek immediate medical advice.

In case of eye contact:

Rinse opened eye for several minutes under running water. Then consult doctor.

If swallowed:

Seek medical treatment.

Most important symptoms and effects, both acute and delayed

No data available

Indication of any immediate medical attention and special treatment needed

No data available

---

SECTION 5. FIREFIGHTING MEASURES

Extinguishing media

Suitable extinguishing agents

Special powder for metal fires. Do not use water.

For safety reasons unsuitable extinguishing agents

Water.

Special hazards arising from the substance or mixture

If this product is involved in a fire, the following can be released:

Metal oxide

Advice for firefighters

Protective equipment:

Wear self-contained breathing apparatus.

Wear full protective suit.

---

SECTION 6. ACCIDENTAL RELEASE MEASURES

Personal precautions, protective equipment and emergency procedures

Use personal protective equipment. Keep unprotected persons away.

Ensure adequate ventilation

Environmental precautions:

Do not allow material to be released to the environment without official permits.

Methods and materials for containment and cleanup:

Collect mechanically.

Prevention of secondary hazards:

No special measures required.

Reference to other sections

See Section 7 for information on safe handling

See section 8 for information on personal protection equipment.

See Section 13 for information on disposal.

---

SECTION 7. HANDLING AND STORAGE

Precautions for safe handling

Keep containers tightly sealed.

Store in cool, dry place in tightly closed containers.

Information about protection against explosions and fires:

The product is not flammable

Conditions for safe storage, including any incompatibilities

Requirements to be met by storerooms and containers:

No special requirements.

Information about storage in one common storage facility:

Store away from oxidising agents.

Further information about storage conditions:

Keep container tightly sealed.

Store in cool, dry conditions in well-sealed containers.

Specific end use(s)

No data available

---

SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION

Additional information about design of technical systems:

Properly operating chemical fume hood designed for hazardous chemicals and having an average

face velocity of at least 100 feet per minute.

Control parameters

Components with critical values that require monitoring at the workplace:

Not required.

Additional information:

No data

Exposure controls

Personal protective equipment

General protective and hygienic measures

The usual precautionary measures should be adhered to in handling the chemicals.

Keep away from foodstuffs, beverages and food.

Instantly remove any soiled and impregnated garments.

Wash hands during breaks and at the end of the work.

Maintain an ergonomically appropriate working environment.Breathing equipment:

Use breathing protection with high concentrations.

Protection of hands:

Inspect gloves prior to use.

The selection of the suitable gloves does not only depend on the material, but also on further marks of

quality and varies from manufacturer to manufacturer.

Material of gloves

Impervious gloves

Eye protection:

Safety glasses

Body protection:

Protective work clothing.

---

SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES

Information on basic physical and chemical properties

Appearance:

Form: Powder

Smell: No data available

Odor threshold: No data available.

pH: N/A

Melting point/Melting range: No data available

Boiling point/Boiling range: No data available

Sublimation temperature / start: No data available

Flash point: N/A

Inflammability (solid, gas)

No data available.

Ignition temperature: No data available

Decomposition temperature: No data available

Self-inflammability: No data available.

Danger of explosion: Product is not explosive.

Critical values for explosion:

Lower: No data available

Upper: No data available

Steam pressure: N/A

Density

No data available

Relative density

No data available.

Vapor density

N/A

Evaporation rate

N/A

Solubility in Water (H

2

O): No data available

Partition coefficient (n-octanol/water):

No data available.

Viscosity:

Dynamic: N/A

Kinematic: N/A

Other information

No data available

---

SECTION 10. STABILITY AND REACTIVITY

Reactivity

No data available

Chemical stability

Stable under recommended storage conditions.

Thermal decomposition / conditions to be avoided:

No decomposition if used and stored according to specifications.

Possibility of hazardous reactions

No dangerous reactions known

Conditions to avoid

No data available

Incompatible materials:

Oxidising agents

Hazardous decomposition products:

Metal oxide

---

SECTION 11. TOXICOLOGICAL INFORMATION

Information on toxicological effects

Acute toxicity:

No effects known.

LD/LC50 values that are relevant for classification:

No data

Skin irritation or corrosion:

May cause irritation

Eye irritation or corrosion:

May cause irritation

Sensitization:

No sensitizing effect known.

Germ cell mutagenicity:

No effects known.

Carcinogenicity:

No classification data on carcinogenic properties of this material is available from the EPA, IARC,

NTP, OSHA or ACGIH.

Reproductive toxicity:

No effects known.

Specific target organ system toxicity - repeated exposure:

No effects known.

Specific target organ system toxicity - single exposure:

No effects known.

Aspiration hazard:

No effects known.

Subacute to chronic toxicity:

No effects known.

Additional toxicological information:

To the best of our knowledge the acute and chronic toxicity of this substance is not fully known.

---

SECTION 12. ECOLOGICAL INFORMATION

Toxicity

Aquatic toxicity:

No data available

Persistence and degradability

No data available

Bioaccumulative potential

No data available

Mobility in soil

No data available

Additional ecological information:

Do not allow material to be released to the environment without official permits.

Water hazard class 1 (Self-assessment): slightly hazardous for water.

Do not allow undiluted product or large quantities to reach groundwater, water courses, or sewage

systems.

Avoid transfer into the environment.

Results of PBT and vPvB assessment

PBT:

N/A

vPvB:

N/A

Other adverse effects

No data available

---

SECTION 13. DISPOSAL CONSIDERATIONS

Waste treatment methods

Recommendation

Hand over to disposers of hazardous waste.

Must be specially treated under adherence to official regulations.

Consult official regulations for proper disposal.

Uncleaned packagings:

Recommendation:

Disposal must be made according to official regulations.

---

SECTION 14. TRANSPORT INFORMATION

UN-Number

ADR, IMDG, IATA

None

UN proper shipping name

ADR, IMDG, IATA

None

Transport hazard class(es)

ADR, IMDG, IATA

Class

None

Packing group

ADR, IMDG, IATA

None

Environmental hazards:N/A

Special precautions for user

N/A

Transport in bulk according to Annex II of MARPOL73/78 and the IBC

Code

N/A

Transport/Additional information:

Not dangerous according to the above specifications.

---

SECTION 15. REGULATORY INFORMATION

Safety, health and environmental regulations/legislation specific for the substance or mixture

Australian Inventory of Chemical Substances

Substance is not listed.

Standard for the Uniform Scheduling of Drugs and Poisons

Substance is not listed.

National regulations

Information about limitation of use:

For use only by technically qualified individuals.

Water hazard class:

Water hazard class 1 (Self-assessment): slightly hazardous for water.

Other regulations, limitations and prohibitive regulations

ELINCS (European List of Notified Chemical Substances)

Substance is not listed.

Substance of Very High Concern (SVHC) according to the REACH Regulations (EC) No. 1907/2006.

Substance is not listed.

The conditions of restrictions according to Article 67 and Annex XVII of the Regulation (EC) No

1907/2006 (REACH) for the manufacturing, placing on the market and use must be observed.

Substance is not listed.

Annex XIV of the REACH Regulations (requiring Authorisation for use)

Substance is not listed.

Chemical safety assessment:

A Chemical Safety Assessment has not been carried out.

---

SECTION 16. OTHER INFORMATION

Safety Data Sheet according to Regulation (EC) No. 1907/2006 (REACH). The above information is

believed to be correct but does not purport to be all inclusive and shall be used only as a guide. The

information in this document is based on the present state of our knowledge and is applicable to the

product with regard to appropriate safety precautions. It does not represent any guarantee of the

properties of the product.