IF5162 (Discontinued) 1200C 5 Side Heating Atmosphere Controlled Muffle Furnace KSL-1200X-AC-5S

Features

• Double-layer stainless steel structure for maximum vacuum and safety,
• The refractory alloy muffle is built-in with a water-cooling wall with dimensions 470 L*410W*550H (mm), which can stand at positive pressure up to 0.06Mpa and vacuum up to - 0.09Mpa.
• High-purity porous alumina is built-in inside of the refractory alloy muffle as thermal insulation
• Water cooling front door and air-cooling shell
• Built-in Pressure gauge, vacuum valves, and two gas flowmeters.
• The furnace be used with Inert gas or vacuum
• A refractory ally box inside the heating chamber is optional for better inert gas control

Chamber Dimensions

• 400*400*400 mm (64L)
• Kathal Fe-Cr-Al heating elements

Power

• 208 -240V Single Phase 50/60 Hz
• 9.5 kW
• Note: Power cable included without a plug. Please install a plug by yourself or click the link below the picture to choose a plug according to your country or your lab requirement

Operating Temperature

• Max. 1200℃ (≤1 hour)
• 1100℃ continuously
• +/- 2℃: 200*200*200 mm, Chamber Center
• +/- 4℃: 400*400*400 mm, Chamber Center

Temperature Control System

• YD858P temperature controller is included.
• Proportional–integral–derivative control (PID control) and auto-tune function
• 50 segments programmed with ramping, cooling, and dwelling steps
• +/- 1℃ temperature control accuracy
• Default DB9 PC communication port

Gas Flow Control & Vacuum Valve

• Two large float flow meters are installed on the front panel of the furnace body, which can pass in two different gases at the same time, and then mix them into the furnace.
• 1 KF25 vacuum interface, installed on the left side of the furnace body, connected to the vacuum pump
• A two-stage rotary vane vacuum pump is installed at the bottom of the furnace body

Water Cooling

• A 16L/min recirculating water chiller is included for cooling the furnace KJ5000
• Short water power off and Over-temperature alarm built-in

Working Gases

• All types of inert gases such as N2 and Ar at ≤ 0.03Mpa.
• Pure oxygen gas≤0.03Mpa. but need modifying internal connection wire for anti-oxidation, please call us in advance if you use O2 gas
• Low vacuum 10-1 torr due to fibrous alumina insulation material. Using 5% H2 + Ar will improve oxidation during heating. For oxygen-sensitive material, please use a hydrogen furnace

Shipping Weight

35 kg

Warranty

• One-year limited warranty with lifetime support.
• ATTENTION: Any damages caused by the use of corrosive and acidic gases are not under the coverage of SAM One Year Limited Warranty.

Compliance

• CE Certified
• NRTL or CSA certification is available upon request at extra cost.